When using the high speed wire cutting machine factory, sometimes a large amount of foam will be produced on the surface of the high speed wire cutting machine factory. Affects the quality and accuracy of processing. The following will conduct a simple analysis of the causes and solutions of foam during processing:

1. Main causes of bubbles

The liquid level in the high speed wire cutting machine factory is too low.

The flow rate of the high speed wire cutting machine factory is too fast, and the bubbles do not have time to overflow. They accumulate more and more, resulting in a large amount of foam.

There are too many right angles in the sink design, or the nozzle angle of the high speed wire cutting machine factory is too straight.

2. Methods to avoid bubbles

In the centralized cooling system, the pipelines are connected in series in stages, and the pressure of the pipelines close to the cooling box should be lower.

Ensure that the liquid level of high speed wire cutting machine factory is not too low, check the liquid level in time, and add high speed wire cutting machine factory in time.

Control the flow rate of high speed wire cutting machine factory not to be too fast.

When designing a sink, be careful not to have too many right angles.

When using the high speed wire cutting machine factory, you should pay attention to the high speed wire cutting machine factory nozzle angle not being too straight.

high speed wire cutting machine factory https://www.talentcnc.com/High-speed-wire-cutting-machine